
Measure the playing surface, not the table
Don't measure the table — measure the flat playing surface: the area where the tiles actually land, inside the lip or rail. An automatic mahjong cabinet is 95–98 cm wide, but the playing surface inside it is 86–90 cm. Order by the cabinet and the mat comes out 8 cm too large — the kind of large that will not lie flat.
The second dimension is the recess depth. If the playing surface sits 15 mm below the lip, a 5 mm mat is fine but a 5 mm mat with a binding is not. One photo with a tape laid across it, showing the depth of the lip, saves a re-cut.
The standard three-step measuring method is in the size guide →. Below: where standard sizes fail.
Four tables, four answers
| Table type | Playing surface | Mat size | Watch for |
|---|---|---|---|
| Automatic folding table, four players | 86–90 × 86–90 cm | Exact fit, no overhang | Cup-holder recesses in the frame |
| Fixed square dining table | 90 × 90 or 100 × 100 cm | Playing surface + 20 mm overhang | Over 40 mm overhang will climb the lip |
| Round table | Ø 80–100 cm | Round, Ø = playing surface | A square mat leaves four gaps |
| American mahjong table | 86 × 86 cm (34 in) | 86 × 86, or 88 with 10 mm overhang | Centre folding-hinge ridge |
| Oversized banquet table | 100–120 cm | Cut to size | No stock size — custom cut required |

The 3 cm failure
Two failure modes, both about 3 cm off. Too large: the mat climbs a few centimetres up the lip, the edge lifts, and the mat is now resting on an angle — corners curled, never flat again. Too small: a 2 cm gap opens between the mat edge and the lip, and tiles drop straight through it when you build a wall quickly.
Neither is a manufacturing defect, and neither can be fixed afterwards. That is why we ask for the playing-surface measurement and a photo, instead of accepting "90 × 90, standard size".
If your table isn't listed
Send the width and depth of the flat area, a photo with a tape laid across it, and the height of the lip above the playing surface. That is enough for us to cut to the millimetre — no tooling fee, one-piece minimum.
If the playing surface is shaped or non-rectangular — a table with rounded corners cut for the dealer, or an octagonal top — send an overhead photo plus two dimensions and we will draw the outline. shaped mats →

Gallery
On the machine floor
Plate 03

