Product line 10 / 12 · office chair floor mats
Chair mats crack. Not because the plastic is bad, but because a 90 kg point load on five castors, in a cold room, on a mat that was rolled for shipping, is a fatigue test that most 1.2 mm PVC fails in a year. The fix is thickness, material and how it is packed — in that order.
From-price is an ex-factory (EXW Xiamen) unit price — excludes tax, shipping and packaging. Final quote varies with size, material, quantity and destination.

On the press





| Floor | Back | Why |
|---|---|---|
| Carpet, low pile | Cleated (0.5 in spikes) | Spikes key into the pile so the mat cannot walk |
| Carpet, deep pile | Cleated, longer spikes | Short spikes bottom out and the mat slides |
| Hardwood / laminate | Flat, smooth | Cleats would dent the finish; a flat back rides on it |
| Tile / stone | Flat, with a rounded edge | A sharp edge chips on stone and trips on a threshold |
| Vinyl plank | Flat, matte | Glossy backs can plasticiser-stain vinyl over years |
What you can specify

The four causes of a cracked mat
Too thin. 1.2 mm PVC is a disposable product. 2 mm polycarbonate is not. The difference in material cost is small; the difference in service life is a factor of three.
Cold. PVC embrittles below about 10 °C. A mat by a door in a warehouse office, or in an unheated studio, cracks at a castor point in the first winter. Polycarbonate does not.
Wrong face up. A cleated mat used flat on hardwood concentrates the whole load on five spikes and punches through. The cleats must key into carpet or the mat must be flat.
Rolled for shipping. A mat that arrives with a 30 mm curl never sits flat, so castors ride the edge and the lip takes a point load it was not designed for.
Who buys these
Pallets of 90 × 120 cleated mats, delivered flat, invoiced per project.
The printed fabric-faced version, where the mat is part of the room rather than a plastic afterthought.
Hard-floor mats with a bevel edge, replaced on a cycle as chairs move between desks.
Neutral mats in the two sizes that cover 80% of desks, held as a stock item.
Plates






Questions
Artwork and a table measurement is all we need. No deposit, no tooling fee, no minimum beyond one piece.